-
All design and construction (manufacturing) activities require conversion of ideas and concepts into drawings for their execution. Large part of this job is done through Orthographic Projection (which was covered in Part I of this course). However, most of the times, 2-D drawings are difficult to apprehend in the absence of a 3-dimensional representation of the same. A 3-D visualization adds clarity to the idea and makes the process of design to construction much simpler. There are several techniques available for visualizations.The two methods discussed here in this course are the most widely accepted ones. This course will teach-1.Isometric projections2.Axonometric projectionsPRE-REQUISITE:NilINDUSTRY SUPPORT:Nil.INTENDED AUDIENCE:Bachelor of Engineering in any discipline; Bachelor of Architecture
-
Week 1:Introduction to isometric projection and isometric Scale; Isometric projection of planar figures- quadrilaterals; Isometric projection of planar figures- circles, semi circles and curves; Isometric projection of straight prisms; Isometric projection of straight pyramidsWeek 2:Isometric projection of Straight Cylinders; Isometric projection of Cones; Isometric projection of Frustums of cones and pyramids; Isometric projection of section of solids; Isometric projection of spheres
Week 3:Isometric projection of combination of solids; Isometric Projection of intersecting solids; Converting orthographic views to isometric drawing-1; Converting orthographic views to isometric drawing-2; Converting Isometric drawing to orthographic views
Week 4:Introduction to axonometric projection; Axonometric projection of planar figures- quadrilaterals, circles and curves; Axonometric projection of prisms and pyramids; Axonometric projection of Cylinders, cones and spheres; Axonometric projection of intersecting solids and combination of solids.
